www.etrailer.com Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information. Well begin our install by actually mounting the camera on the lower bolts of the license plate. This does reside on top of the license plate. There is one other note, this comes with spacers that allow you to tilt this up or down depending on your vehicle. Next you need to route this wire up along the edge here, and up to the hinge point and back down to the tail light. What were going to do first is wrap this wire around the bottom. We measured and theres plenty of room between the hatch and the tailgate. What were going to do is slice a little hole here to run the wire through so its not sticking between the grommet. Now well push this wire into the groove and work our way up towards the hinge. This will come off first which weve loosened up. Now well take off this unit and we trace our wire back down through here. Be sure to leave enough room. The next thing we do is make our camera connections to our wire harness. We need to hook up to the reverse light as the camera is energized when you put your vehicle in reverse. The red wire will be the positive lead and well connect it to the blue wire which weve already tested to be sure. The other wire here will be the ground wire which well attach to a black wires because we know theres only one filament here so power is coming in and the ground is coming out. So well make the connection ...
สมัครสมาชิก:
ส่งความคิดเห็น (Atom)
ไม่มีความคิดเห็น:
แสดงความคิดเห็น